My campaign is paused because of bounces: causes and fix
If your campaign has paused because of bounces, it means too many emails didn't arrive. Here is why it happens, how to fix it, and how to change the limit or turn the protection off.
When your campaign pauses
A bounce is an email that doesn't arrive because the address doesn't exist or is misspelled. Mailerfind counts them and pauses the campaign when they go above a percentage of your sends. By default it is 5%.
Most common causes
- The list has invalid addresses. This is the most common cause: emails with typos or belonging to people who no longer use that account.
- You didn't verify the list before sending. Without verifying it, you don't know how many addresses will fail.
- You're sending to very few contacts. With few sends, just a few bounces already make a high percentage.
How to fix it
1. Verify your list
- Verify the emails in your list to remove the invalid addresses. We explain how in Email verification.
- If you use MillionVerifier, you can connect it to Mailerfind.
2. Resume the campaign
- Open the campaign.
- Click Resume.
When you resume, the bounce counter goes back to 0. If the campaign goes above the limit again, it will pause again.
Change the limit or turn the protection off
You can raise or lower the bounce limit, or turn the protection off, from the campaign settings.
- Open the campaign and click Edit.
- Go to the Settings step and open the Protection tab.
- To change the limit, type the percentage you want in Auto-pause on bounce rate. To turn the protection off, switch off Bounce protection.

If you turn it off, Mailerfind no longer warns you or pauses the campaign because of bounces, although it keeps counting them.
If it still doesn't work
Write to us in the chat and tell us the campaign name and how many bounces it has.
Updated on: 13/10/2026
Thank you!
